roughing and finish pass

[dewme5]

I'm selecting the bottom face of a pocket. Choosing to rough with a 1/2" EM. Now, I need to go back with a 1/4" EM to clean up the corners, and where webs still exist between areas to small for the larger end mill.

Gibbs cam is new to us, I can knock it out on Pro/NC no problem. I'm working late into the night on this, so any help would be appreciated.

[double a-ron]

Do another roughing op, but check "use stock" and "material only". Its at the bottom of the roughing prosses window.