lynx 85

[breazr]

Does anybody know if there are some rules for naming programs for Lynx 85 controller ?

Something like "only numbers in the program name", or any specific extensions ?

I cannot load a program issued by a CAM package, and i'm sure that the post-processor is OK (or I was told that).

Thanks !

[linatrol god]

Did this problem just start or has it happened since you owned it?
What are you using for communications?
What nesting software are you using?
Does it pass the rs232 test?
Does it have a floppy drive?

[sarrazin15]

what is the good post processor for lynx 85 with enroute3,...