linear actuator

[dgalaxy]

do you guys think this would be a good setup for just plasma cutting or
should i just stick to trying to get a rack and pinion set up

[Weldtutor]

Seems a bit difficult to interpret the photo details & size.
The thumbnail when opened, shows only a slightly larger image.
Is that a belt drive mechanism?
Any additional information might get more responses.

[dgalaxy]

it is a
0.20XL timing belt with a 15 tooth timing pulley mounted to the motor
what do ya think? is this not very durable for plasma

[keebler303]

depends a lot on where its mounted and if you have dust collection. it could probably survive if it was above the gantry. what type of motor does it have? what if any gear reduction? etc.
it always helps to have more information.

Matt

[Weldtutor]

it is a
0.20XL timing belt with a 15 tooth timing pulley mounted to the motor
what do ya think? is this not very durable for plasma

Check post # 6 of this thread:

Plasma Table Build Log Including Free Plans Link, & Pictures by Weldtutor

It shows a plasma table using an XL series timing belt.