THC HELP

[ryguy_nayr]

I am looking for someone in the area that would be willing to come take a look at my machine. I will pay, just let me know how much

I setup consists of a EZ router 4x8 plasma table, thermal dynamics a40 plasma, CandCNC MP1000 THC and Mach 3 software. I believe it is just a problem with Mach software but I need someone to come take a look at it because I am not very good with these things and I have tried everything I can goin back and forth with machsupport

I'm located in Westminster MD so if anyone is able to help me, please let me know


Ryan
ryguy_nayr@hotmail.com

[ryguy_nayr]

Let me know if you are in the area and willing to help. I'm offering up a $1000 reward if someone can figure this thing out.

[Torchhead]

I am looking for someone in the area that would be willing to come take a look at my machine. I will pay, just let me know how much

I setup consists of a EZ router 4x8 plasma table, thermal dynamics a40 plasma, CandCNC MP1000 THC and Mach 3 software. I believe it is just a problem with Mach software but I need someone to come take a look at it because I am not very good with these things and I have tried everything I can goin back and forth with machsupport

I'm located in Westminster MD so if anyone is able to help me, please let me know


Ryan


ryguy_nayr@hotmail.com

Ryan Why not take advantage of our free CandCNC support forum on yahoo groups? We know the MP1000 and MACH and I have hooked up an A60 (although it was to our newer MP3000-DTHCII system using the CPC interface). The support forum has older product manuals and support files. We won't hard sell you and we support all our products regardless of who or where sold it

You need a Yahoo account and You have to join our forum but you are welcome and there are a nice group of guys (about 1750) that have similar setups. Might even find someone close to you!

CandCNCSupport : CandCNC Support Group

TOMcaudle
www.candcnc.com