I have a Cutmaster A60 and I just got the power cable and plug put on it since it comes without a plug. I had a 50amp 4 prong plug installed in my garage. Then on the plasma cutter I put on a 4 wire range cord (6 gauge wire). Its set up with black to L1, white to L2, and the red to L3. The jumper from L2 to L3 has been removed and the jumper from L1 to L4 is still in place. I'm no electrician, so I wanted to double check that I did this right. Appreciate any input.
That's where I found the instructions. I believe it is 3 phase right now and I thought residential homes can't handle that. Don't wanna cause sparks anywhere other than on my sheet metal.
Btw...you, Jim, are everywhere online supporting CNC even if its not your product. Pretty cool!