DIY magnetic torch holder

[adscnc]

i'm interested to know if anyone has been tempted to make their own magnetic torch holder. From the designs i've seen its needs magnets to hold it and a small tapered recess to locate it.

I guess there needs to be some trial and error on both the magnetic hold and the tapered recess. try it and see if it works ...

[keebler303]

I think I have seen home made ones here. Did you search?

Matt

[WSS]

I built two using 30mm square magswitches and some aluminum, they worked OK. I just did a major rerto-fit to our table and decided to use a snap 'n cut to save time. I wish I had done that a long time ago. It is simple and effective, it realigns perfectly. Comes from Oz but I had it fast. Cheap too for what you get.

WSS