Sodick Wire BF 275

[ehsan.amouzegar]

my bf275 doesnt move axises during M00 code execution! What should I do?

[ehsan.amouzegar]

my bf275 doesnt move axises during M00 code execution! What should I do?
Ehsan.Amouzegar@gmail.com

[LaserToolShop]

my bf275 doesnt move axises during M00 code execution! What should I do?
Ehsan.Amouzegar@gmail.com

M00 is a halt command, how did your command line written on your program?
Is the first time you use M00 command?

[sodickappsguy]

like said above the M00 is a hard stop in the program used to stop the machine so that you can remove slugs or move clamps to avoid crashes. When you reach the M00 you should be able to press the ENT button and the cut should continue. Is the issue that the machine will not restart after the M00?