Chermiles Robofil 290 connect to PC

[wasskii]

hello

I'm newbie so be tolerant. My machine's working fine but i want to connect them to PC. I recently bought RS232-USB cable. but don't havy any idea how to cofigurate the machine and PC. There's written in manual to use TRANS3 soft but i can't find them. Also i'm looking for some soft to write programs for my Robofil on PC and simulate the process then using the connection sending them to machine.....

Thx for Your time

[kip0569]

First thing is do you have a Charmilles or Fanuc control? They were made with both. If not sure watch the boot up sequence. That should give you some clues.

[wasskii]

i have Chermilles control. the should be exporting the file from DXF to ISO estension and then i can copy the file on my machine.

[catalincnc]

Does anyone know Robofil Service for 290p in Romania?