| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-27-2008, 10:12 AM
| |||
| |||
Hi guys just wondered if some one could tell me the correct dropper resistors to use with my mill  3x Stepper motors FL60STH86-3008BF 3.9Volt 3Amp Unipolar a 38v power supply and a compucut driver board link to datasheet on steppers : http://www.motioncontrolproducts.co....&products_id=6 i need to make sure i get the right ones first time round as i`m on a tight budget LOL 38v-3.9/3a=11.36ohm i think they should be 12R 50w not 100% anyone confirm this please cheers guys !!!  Last edited by scotty001; 06-27-2008 at 11:01 AM.    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Current Set resistors | xitian | Gecko Drives | 3 | 06-05-2007 11:23 PM |
| Sensing Resistors vs Current limiting Resistors | whitney | Hobbycnc (Products) | 3 | 11-06-2006 12:29 AM |
| Resistors!! How hot? | southernexplore | General Electronics Discussion | 4 | 11-19-2005 10:32 AM |
| What current set resistors do I need. | Apples | Gecko Drives | 7 | 08-31-2005 03:53 AM |
| Bleeder Resistors | bbergami | General Electronics Discussion | 5 | 08-08-2005 06:21 AM |
| | |
Linear Mode
