| |
|
#1
 
11-30-2006, 12:19 PM
| |||
| |||
Hello I wanted to ask a question about a Yaskawa setup. I am new to servo control CNC setups. I am building a new cnc router machine and currently have (3) SGDH-02BE Amps with NS600 Indexers and (3) SGMAH 02BAN21 motors. I wanted to know what would it take to make this setup run. Thanks    |
|
#2
12-18-2006, 02:48 PM
| ||||
| ||||
| Do the drives take a step/direction input or do they require a +/- 10V input?
__________________ "A Helicopter Hovers Above The Ground, Kind Of Like A Brick Doesn't" Greetings From Down Under Dave Drain Akela Australia Pty. Ltd. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
 |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
