| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Metalwork Discussion Discuss everything relating to metal work. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-21-2009, 12:27 PM
| |||
| |||
Hello all, I have an older Parlec Tool presetter model P10-1216 equipped with a CPU (position display is not on the unit, but on a monitor). The video card, a Coreco Oculus TCi XR-M130-11830 is defective and I have looked all over and cannot find one. The presetter is only 10 years old and is discontinued. Any one with suggestions? Thank You!!    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PARLEC Presetter | tgorrell | Calibration & Measurement | 3 | 12-01-2009 09:46 PM |
| Need Help!- Tool Presetter | norzadeug | Calibration & Measurement | 1 | 02-07-2008 02:58 PM |
| Are Parlec vises any good? | gearsoup | Work Fixtures and Hold-Down Solutions | 4 | 10-09-2006 07:11 AM |
| Another presetter problem | jlwright | Daewoo/Doosan | 11 | 07-14-2006 04:21 PM |
| Tool presetter and MDI question. | jlwright | Daewoo/Doosan | 9 | 06-28-2006 06:52 PM |
| | |
Linear Mode
