Need Help! miami Junkyard - CNCzone.com-The Largest Machinist Community on the net!

Maxxxix · #1 07-13-2009, 05:58 AM

Hello guys
Have anyone an idea where I can find a Junkyard around Miami.
Something likes this…
Tks.

CalG · #2 07-13-2009, 11:56 AM

Have you looked out on Tamiami Trail? Used to be a place out there, straight past the airport, then north a bit, Lots of stainless and aviation stuff Also Metal Man was a small place North east of the airport.

It's been 25 years, so who knows.

Cal

Maxxxix · #3 07-13-2009, 03:18 PM

Hello CalG
There's a lot of places to pick up auto parts in this zone. Buy nothing like the picture I send.
Thanks anyway.

CalG · #4 07-14-2009, 08:23 AM

Neither of these two had any auto parts at all. Only metal. 'Times change however.

Maxxxix · #5 07-14-2009, 10:14 AM

Ok CalG
I will go try again to find the places.
Thanks man.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
looking for a mentor in miami (305) are	thesaent14	Mentors & Apprentice Locator	7	08-08-2010 12:58 AM
Need Help!- Miami Step Motor Repair	mak010203	Stepper Motors and Drives	0	08-25-2008 04:43 PM
Where to buy scrap metal in Miami area?	Dembo	General Metalwork Discussion	0	04-22-2008 12:07 AM
a diy junkyard speacial pen plotter, hot cutter	wayword son	Printing, Scanners, Vinyl cutting and Plotters	1	05-14-2007 07:36 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)