Results 1 to 1 of 1

Thread: Integrex 200SY Question

  1. 07-02-2009, 11:31 AM #1
    tricmachine
    tricmachine is offline
    Registered
    Join Date
    Sep 2008
    Location
    United States
    Posts
    5
    Downloads
    0
    Uploads
    0

    Integrex 200SY Question

    Hi, I am trying to do a job using some longer stock. I took the plate off of the back end covering the spindle to slide the rod through that way. After I took the plate off I saw another plate bolted to the spindle with four screws. Can I take this plate off? Ive never seen one on my older machines and do not want to undo something that I can mess up.
    Attached Thumbnails Attached Thumbnails Integrex 200SY Question-img_0351.jpg   Integrex 200SY Question-img_0352.jpg  

« Facility Manager | Kurt Vice Setup Help »

Similar Threads

  1. Need Help!- integrex IG 300IVs
    By mazman in forum Mazak, Mitsubishi, Mazatrol
    Replies: 1
    Last Post: 06-06-2008, 01:34 PM
  2. Camware for Integrex 300-IV ST
    By Jaker in forum Mazak, Mitsubishi, Mazatrol
    Replies: 1
    Last Post: 04-24-2008, 02:04 PM
  3. Mazak Integrex 200 III St ISO/EIA
    By maramb in forum Mazak, Mitsubishi, Mazatrol
    Replies: 19
    Last Post: 11-28-2007, 03:41 PM
  4. Integrex IV help
    By Demon440 in forum Mazak, Mitsubishi, Mazatrol
    Replies: 8
    Last Post: 02-19-2007, 02:21 PM
  5. integrex 50 YB ISO Programming
    By Batman in forum G-Code Programing
    Replies: 3
    Last Post: 12-12-2006, 06:47 PM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.