Nakamura TW20 Parting Off

[redsid66]

Can anybody throw any light on parting off on Nakamura TW20 using parts catcher on sub spindle. Any help would be appreciated.

Redsid66

[extanker59]

I have an old program from a TW20 that has a cutoff op in it. But I'm not sure what you want. Do you want me to type up the relevant parts with the wait codes?

[redsid66]

Hi extanker59

Any help at all would be appreciated. At the moment we are unsure how to get the sub-spindle across and the catcher in position to catch the part.

Regards

redsid66

[extanker59]

OK, here goes. I'm only going to post the relevant sections. Typing, so beware of typos.


%
:4811 (PART DESC)
(LEFT SIDE)
(430F SS, 1.25" DIA STK)
(STICKING OUT 1.95" MIN)
G0G28U0
M10(SAFETY COLLET CLOSE)
M41 (C AXIS DISENGAGE)
G50 S3500
M1

ROUGH FACE TURN
ETC
ECT

N5 (CUTOFF PICKOFF)
G0G28U0W0
M75 (RIGHT PROGRAM START)
T505G99G97S1500M3
X7.Z.015
M101
M102
M11
G4U.5
M103
M104
M10
G4U.5
G0S2500X1.35M6
G75P1000F.004X-.08
M105
M106
W.01
G0G28U0M7S500
Z1.95M5
/M98P9800 (LOAD BAR)
M30
%

i'LL POST SIDE 2 IN A FEW MINUTES. gETTING BUSY

[extanker59]

%
:4812 (PART DESC)
(RIGHT SIDE)
(PART HELD IN 1.25" COLLET)
(EJECTED OUT BY AIR AND EJECTOR)
G50S5500
G28U0W0
M14
M31
M97
M41
M74
M11
M84
M85
M1

N100(CUTOFF PICKOFF)
T200
M101
M96
G0G98W-20.15
G1G98W-1.26F25.
M10
G4U.75
M102
M103
G1G98W2.071F50.
M104
M105
G0G99W2.M97
M106
M3S2500
G0M15G28U0W0
M1


FACE
TURN ETC

N100(EJECT)
G4U.5
G0G28U0W0M5
M14
M73
M15
G4U.2
M11
G4U.2
M14 (AIR BLOW ON TO CLEAR COLLET OF CHIPS)
G4U.5
M74
M15
M31
M1
T200
M30
%

OK, thats it. do you need m code definitions?

[redsid66]

Many thanks for your time. will try this at work tomorrow,and let you know the outcome. Once again many thanks.

[redsid66]

All sorted, Many thanks extanker59 for all your help

Regards
redsid66

[extanker59]

Excellent! Glad to help.