Need Help! 3mm Deep Hole Drilling Parameters ? - CNCzone.com-The Largest Machinist Community on the net!

		CNCzone.com-The Largest Machinist Community on the net! > MetalWorking > General Metalwork Discussion
Need Help!- 3mm Deep Hole Drilling Parameters ?

General Metalwork Discussion Discuss everything relating to metal work.

This forum is sponsored by:

01-20-2009, 04:26 AM

yaji63

Join Date: May 2008

Location: India

Posts: 85

3mm Deep Hole Drilling Parameters ?

permalink

I have an application where i need to drill a 3mm hole to a depth of 90mm in 15/5 PH steel. I have a drill from Titex but it is not working as per their recommended parameters (broken 2 drills till now). Can anyone out there suggest a cutting parameter which can make this operation work ? It would help if you can give me the RPM, Feed/Rev and the Peck depth per peck cycle (i use peck drilling cycle).

thanks a lot

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need advice on drilling a deep hole	protrxrptr17	General Metalwork Discussion	20	10-17-2008 02:52 PM
Deep hole drilling	kalmah	General Metalwork Discussion	8	09-09-2007 10:09 AM
RFQ: Deep hole drilling in several materials	m-134b	Employment Opportunity	3	08-23-2007 05:55 PM
Concentric deep hole drilling	m-134b	General Material Machining Solutions	7	07-30-2007 07:45 PM
Deep hole drilling on OKK	eddie	G-Code Programing	1	09-21-2005 06:55 PM

All times are GMT -5. The time now is 01:32 PM.