| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Metalwork Discussion Discuss everything relating to metal work. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-09-2009, 11:14 PM
| ||||
| ||||
I am in dire need of some 3/8-16 face sealing flange nuts of some sort . I have a 20 mva transformer that the tap changer inspection door is leaking oil and I need some of these nuts bad. Please respond if you know where I can get a few! Thanks  |
|
#2
01-10-2009, 02:32 AM
| |||
| |||
| Get 2 different sizes of o-rings. One thinner one that you need to really stretch to fit over the stud, and a thicker one that you just need to stretch a little. Roll the thinner one on 1st (it will be deformed in the threads) and then the thicker one. Next you get a close fitting washer (not the standard sloppy fit ones, it may help to get a metric one here) and put it on followed by a regular nut.
__________________ On all equipment there are 2 levers... Lever "A", and Lever F'in "B" |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 3 Part sealing? | pp-TG | Mechanical Calculations/Engineering Design | 2 | 02-27-2007 07:41 PM |
| 3/4-6 Nuts? Where to find? | Joe Petro | Linear and Rotary Motion | 2 | 03-25-2006 01:26 AM |
| Can't find nuts! | Xterrian | DIY-CNC Router Table Machines | 3 | 08-07-2005 01:14 AM |
| angular contact bearings face to face?? | powerfade | DIY-CNC Router Table Machines | 2 | 06-18-2005 11:01 PM |
| Sealing a collet? | HuFlungDung | General Metal Working Machines | 6 | 04-13-2003 05:36 PM |
| | |
Linear Mode
