| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Metalwork Discussion Discuss everything relating to metal work. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-08-2009, 09:37 AM
| |||
| |||
Can anyone explain to me or point me in the direction of a good resource to learn manual cutter comp when lathe programing. I have only written a handfull of programs and am still a little stumped on how and why to manual comp the cutters. I recently build a tube bender die and i used a pattern repeat cycle to machine out the radius on the lathe and i had to manual comp the cutter because the machine could not pick up g41 or g42 on a cycle. when it was rouging . Any way i had help from a teacher @ the college where i took machinng a few years back but i really want to learn it on my own! Thanx   |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- FANUC O-MD Control MAnual | m_bhui | Mastercam | 4 | 11-03-2008 10:58 PM |
| Cutter comp on an id hole< cutter diam.?? | PaintItBlue | Haas Mills | 5 | 05-05-2008 06:30 PM |
| Fanuc Tip code 8 cutter comp question | demeyert | Fanuc | 10 | 04-04-2008 08:03 AM |
| CUTTER COMP FANUC 18M? | PICMAN | Fanuc | 1 | 12-07-2007 11:53 AM |
| dynapath control cutter comp | PETE1968 | Post Processors for MC | 7 | 04-13-2006 06:37 AM |
| | |
Linear Mode
