Problem anilam crusader m series swap with 1100s - CNCzone.com-The Largest Machinist Community on the net!

11-08-2008, 11:42 AM

Jetpylot33 Jetpylot33 is offline

Join Date: Nov 2008

Location: usa

Posts: 13

anilam crusader m series swap with 1100s

permalink

I have a supermax mill with anilam crusader series controls that I just swapped out to the anilam 1100s. Problem is the servoe from the old machine haves 5 wires going to them and the new one has 10 wires going to them. I have the digrams for both controls but I not and electiction and just learning to machine. Does anyone have an idea as of what I should do? I would really appreciate the help? Thanks. Rob

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- supermax/anilam crusader series m	Jetpylot33	General CNC (Mill and Lathe) Control Software (NC)	10	08-01-2010 08:45 PM
Anilam Crusader ML Series Board	R&B	CNCzone Club House	1	11-05-2008 11:09 PM
Anilam Crusader Series M	Maurice	CNCzone Club House	0	08-07-2008 03:57 PM
Anilam Crusader ML Series Board	R&B	General Electronics Discussion	0	10-02-2006 02:36 PM

All times are GMT -5. The time now is 03:47 PM.