Need Help! Milling HY-100 - CNCzone.com-The Largest Machinist Community on the net!

MAXXL · #1 10-13-2008, 08:31 PM

Here is the delema. I have a 3.5" plate 65" tall 100" long. I am cnc Milling both sides. I am required to use High speed end mills on all surfaces. no carbide whatsoever.
Can anyone recomend surface footage and chip loads for this material. I am useing a 1.250" coarse tooth corn cob roughing mill. I am side milling 18MM. and the depth of cut is 12 MM. My current speeds are 200 RPM at 4 inches per minute. any help would be greatly appreciated.

MAXXL · #2 10-15-2008, 11:11 PM

bump

MAXXL · #3 10-30-2008, 05:23 AM

Anyone have any ideas on where I can find the info? I did find what was in HY-100. will post shortly.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Milling with bottom vs milling with side?	REVCAM_Bob	CNCzone Club House	13	06-30-2008 09:23 AM
Newbie- V21 2d milling help	bseibenick	BobCad-Cam	2	04-28-2008 09:45 PM
3D IH Milling	wildcat	Industrial Hobbies (Support forum)	30	03-09-2007 05:32 PM
Milling a PCB	Ayjay	General Electronics Discussion	3	05-19-2006 11:01 PM
PCB milling	FabCNC	General Metalwork Discussion	5	05-24-2005 07:44 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)