| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Metalwork Discussion Discuss everything relating to metal work. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-19-2008, 05:00 PM
| |||
| |||
Gentlemen, I have aquired an old shw mill with a ISO50 spindle. It came with some tooling but the collet set is all metric. I would like to find either a full collet set in fractional inch for the ISO50 spindle or learn how to identify the collets I have to see if I can get fractional collets to fit the collet chuck that came with the machine. Any help would be greatly appreciated including suppliers that handle ISO50 tooling. Thanks  |
|
#2
09-19-2008, 05:44 PM
| ||||
| ||||
| ISO50 should be the same as NMTB50 so far as the taper and threads are concerned.
__________________ First you get good, then you get fast. Then grouchiness sets in. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
