Need someone to machine small parts.

[rayzorl1]

Ok the only thing worse than my drawing skills are my lathe finishes.I need someone to make a prototype part for a shaft drive system for a r/c boat its a small part or 3 i do have a drawing and compared to the stuff you guys do seems very simple.it will require lathework and hardening.thx Ray

[handlewanker]

If you get real desperate I might be able to help.
Post a drawing/sketch anyway.
Ian.

[rsaia]

We can make this for you but I think you should look for a smaller shop
SEE ou website www.armstrong-tech.com

Thanks
Ron

[rayzorl1]

If you get real desperate I might be able to help.
Post a drawing/sketch anyway.
Ian.

I hope I dont sound real desperate but part#1 is what I need first, its a piece of a new drive system whitch only consists of three parts.[IMG]please send me your email and ill send picture thx Ray

[mrreynolds]

Where are you Ray? From the other side of the US we might could help you too if we are closer. We are in Alabama.
lester

[rayzorl1]

Where are you Ray? From the other side of the US we might could help you too if we are closer. We are in Alabama.
lester

Im in bonita springs fl any help would be good help thx Ray

[mrreynolds]

send me a print, and when you need it and
I'll slide it in shop between scheduled jobs if it won't tie us up for long.

[snovak240]

PM sent Please e mail the info.

Thanks

[handlewanker]

Hi Ray, received the drawing OK, It's a straight forward turning piece.

I'm sure you can get it made locally by anyone with a bit of lathe knowledge.

Like I said, if you get desperate, with a few more details it can be done.
Ian.

[handlewanker]

Hi Ray, second drawing received OK.
No problem to make, just the sizes in metric to three decimal places are unrealistic, but as an evaluation will suffice as most of the sizes can be rationalised for making.

Like I said, if you run out of options give me a call on my private line and I'll let you have an estimate.
Ian.

[nick4]

Hey ray i can make the parts, just send me a drawing.