wadkin ux post needed

[kevpugh]

Hi all

Please can some one give me a post for a wadkin ux,cc100 controller.I have one but it dont work.The machine has two heads with four air drills,with a bosch panel.I am using alphacam but cant get it to change heads or drill.please can someone help,many thanks.

[Somerset CNC]

Hi
Having the same problem mate, Edgecam to Bosch CC120 any joy let me know

[shaunbirm]

Hello there i have a post for a WADKIN UX two head router with four drills for CC120.
I adapted it slightly to suit our machine at the time.
The adaption was just to tell you the operator several messages and tooling details.

We had adapted it from a generic post which we got from alphacam at the time

Just let me know if you still want it.

Shaun

[Somerset CNC]

Hello there i have a post for a WADKIN UX two head router with four drills for CC120.
I adapted it slightly to suit our machine at the time.
The adaption was just to tell you the operator several messages and tooling details.

We had adapted it from a generic post which we got from alphacam at the time

Just let me know if you still want it.

Shaun

Hi Shaun

Thanks for your reply, yes still need the post if you could post on the site that would be great, if thats possible?
Thanks

[shaunbirm]

Hi there,

I've attached it as a text file.
When you get it to your pc change the file name from (.txt) at the end and put in .arp

Then you can open it in alpha edit as a post.

When it generates the program after the G4F4 take out the next line that says G0 Z10 and the program will run fine.
I've not taken the line out of the post because you need it when its pocketing.

When you are generating your program it brings up details about tooling and baseboards etc if you don't need then just go into post and amend them.
But it is useful to put info in for operator.

Give me a shout if you need more help

Shaun