| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Metalwork Discussion Discuss everything relating to metal work. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#13
 
09-03-2004, 02:59 PM
| |||
| |||
| Yes, an angle bracket on the bottom and a muffler clamp on the top. I may have to scrap the angle on the bottom though, I'm losing about an eighth clearance their. I may just try and mount a full size router on it, I think it should be tough enough. I'm afraid if I try machining aluminum with the laminate trimmer the tool/collet is going to give a lot of chatter. Thanks for the compliments! Joe  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| G-Code to DXF | WayneHill | OpenSource Software | 200 | 04-22-2012 09:51 PM |
| Visual Basic Controller Project | dwwright | Visual Basic | 29 | 02-14-2011 01:24 PM |
| Ball end mill help | foamcutter | General Metalwork Discussion | 4 | 07-21-2010 12:59 PM |
| What type of end mill is used for plastic? | replicapro | General Metalwork Discussion | 10 | 07-21-2010 10:29 AM |
| Pro/manufacture -number of decimal places arc events | dsergison | Post Processor Files | 4 | 05-27-2005 12:50 PM |
| | |
Linear Mode
