Need Help! Step when milling arcs - CNCzone.com-The Largest Machinist Community on the net!

01-30-2008, 07:18 AM

dpkozi

Join Date: Jan 2008

Location: usa

Posts: 1

Step when milling arcs

permalink

We have two Matsuura 800 vertical machining centers. When milling a diameter with one of them we get a step at the "Y" axis centerline. I have tried to tighten up the backlash but that didn't help. Any suggestions???

Thanks, Dan

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
3d arcs?	stevespo	BobCad-Cam	10	08-31-2007 08:02 PM
Step by step cnc plasma with parts list and links.	massajamesb	CNC Plasma and Waterjet Machines	8	07-08-2007 10:22 PM
TORQUE: FULL STEP vs half step	Glidergider	Stepper Motors and Drives	0	02-27-2007 02:02 PM
step by step instruction for building controller	avengine	CNCzone Club House	0	04-21-2006 07:24 AM
Single Step/Half Step Question	Hawkeye	DIY-CNC Router Table Machines	4	11-20-2003 10:28 AM

All times are GMT -5. The time now is 01:12 PM.