Mazak M plus parameter? - CNCzone.com-The Largest Machinist Community on the net!

MrUZU1 · #1 06-08-2007, 01:18 AM

Anyone know if it is possible to set a mazak parameter to 1/4 circle interpulation instead of 1/2 circle interpulation and if so what parameter is it .I seem to have either over looked it in the book or its not in the book.

The machine is a mazatec FH-880.

CNCRim · #2 06-08-2007, 01:46 AM

You should able to do that... look under U parameter.

Mazaholic · #3 06-08-2007, 06:56 AM

can't you do that with the line machining?

MrUZU1 · #4 06-08-2007, 08:13 AM

Thanks for the reply.Any clue to what # on the U parameter?

CNCRim · #5 06-08-2007, 09:50 PM

One easy way to find what parameter for it is look under TPC, and whatever the retract is match...... blah blah then change parameter.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mazak QT-200,Mazak VTC-160A,Mazak FJV-250 all pcb problem	sting_dot	Mazak, Mitsubishi, Mazatrol	0	05-21-2007 09:20 PM
parameter 64	swartling	Haas Mills	0	02-20-2007 05:57 PM
Parameter changes	jorgehrr	G-Code Programing	9	02-15-2007 09:06 PM
Mazak OP2 parameter	xr135	Mazak, Mitsubishi, Mazatrol	0	05-17-2006 03:11 PM
Mazak T2 parameter input format?	nervis1	Mazak, Mitsubishi, Mazatrol	2	02-05-2006 11:41 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)