Anyone use a floating tap holder for 4-40 in 6061? - Page 2 - CNCzone.com-The Largest Machinist Community on the net!

		CNCzone.com-The Largest Machinist Community on the net! > MetalWorking > General Metalwork Discussion
Anyone use a floating tap holder for 4-40 in 6061?

General Metalwork Discussion Discuss everything relating to metal work.

This forum is sponsored by:

Page 2 of 2

#13

08-05-2009, 05:19 PM

Join Date: May 2009

Location: USA

Posts: 92

I have done 4-40 threads with tension- compression tap holders in 6061 with
no problems whatsoever.
In inch mode feed would be 1 divided by 40 x rpm.

Last edited by maz43; 08-05-2009 at 05:46 PM.

Page 2 of 2

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Floating head on Kress router	zoltan	Mechanical Calculations/Engineering Design	3	03-02-2007 07:52 AM
Floating spindle idea	originator	General Metalwork Discussion	7	11-19-2006 08:39 AM
Floating Head Switch?	Redline	CNC Plasma and Waterjet Machines	9	09-18-2006 08:21 AM
Floating Nut Design	Barefooter	DIY-CNC Router Table Machines	31	06-03-2005 09:47 AM
Floating upper nozzle	Klox	CNC Plasma and Waterjet Machines	10	05-10-2003 06:49 AM

All times are GMT -5. The time now is 03:11 AM.