Halogen bulb needed - CNCzone.com-The Largest Machinist Community on the net!

klysons · #1 05-16-2007, 12:22 AM

I have a Tree 310 with a halogen light ont he left side, but the bulb is very difficult to find. It is a tiny one with 2 little hard wire connectors sticking out about 1/4" and 24v. Any catalog I look in only shows the normal 12v auto type bulb. Any ideas on where to find this would be greatly appreciated.

Shotout · #2 05-16-2007, 03:09 PM

Originally Posted by klysons

I have a Tree 310 with a halogen light ont he left side, but the bulb is very difficult to find. It is a tiny one with 2 little hard wire connectors sticking out about 1/4" and 24v. Any catalog I look in only shows the normal 12v auto type bulb. Any ideas on where to find this would be greatly appreciated.

Check this url and see if any of these match
http://www.lightbulbsdirect.com/Merchant2/merchant.mvc?

klysons · #3 05-16-2007, 03:19 PM

Excellent!!!

thanks so much.

Shotout · #4 05-17-2007, 09:05 AM

Originally Posted by klysons

Excellent!!!

thanks so much.

Any time

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
help needed	tomcook	G-Code Programing	3	07-06-2006 04:42 AM
Help needed	widgitmaster	CNCzone Club House	2	12-17-2005 04:27 PM
Help needed	BlackIbanez	G-Code Programing	1	11-23-2005 02:22 PM
New VMC needed	Scott_bob	General Metal Working Machines	1	08-22-2004 01:19 PM
what is needed for cnc	kenlambert	General Electronics Discussion	6	02-03-2004 08:59 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)