cutting thin metal

[clittle]

I am trying to find a company that will cut a antique car logo out of thin sheet metal (0.020 approx), the object is about 2.7 by 0.76 inches. Most any metal will do.

I have a DXF CAD file or could provide any image file required. Essentially it is a 2D object that could be cut by a laser or perhaps a waterjet, although the cut width might be critical.

thanks

charlie

[rustamd]

http://www.metalcards.com/

*never ordered anything from them, but have sample, very good quality. Here is a pic of the business card i have(.020 SS)

http://i178.photobucket.com/albums/w...k/IMG_1240.jpg

http://i178.photobucket.com/albums/w...k/IMG_1239.jpg

[clittle]

Rustamd,

Thank you kindly....this lead looks very promising...I appreciate the time you spent in my behalf.

charlie

[Bud Guitrau]

clittle,

If you only need one such part, then stick with laser or the like. If you need a lot of these, wire EDM can very accurately cut stacks of these with little regard to kerf width (.012-.015"). Consider a 1" stack would produce 50 identical logos.

Regards,

Bud