offsetting tools

[earl]

Does anyone know how to offset tools on a fanuc 6m (or 6t)? I have programmed and set up many funuc controlled machines and don't know if I have a parameter problem or what.
thanks earl
earlvf@yahoo.com

[cncdigger]

What is your problem?

[cncdigger]

Any alarms? On 6M, tool lenght offset are stored in registers 01 to 99. To apply TLO, G90 G45 Z1.0 H01

[jackson]

Originally Posted by cncdigger Any alarms? On 6M, tool lenght offset are stored in registers 01 to 99. To apply TLO, G90 G45 Z1.0 H01

I am not sure what control your on but all the fanucs i know use
G0G54X0Y0S1000M3
G43H1Z.1

[cncdigger]

It's a 1982 Mazak V 7.5 with a FANUC 6M control.

It uses a G45 and negative value offsets a typical program start would be as follows:

O1111(/P FACEPLATE)
N20T07
N30M06T00
N40G00G20G17G90
N50T00
N60G54
N70M39
N80M03S2000
N90X19.100Y-1.9
N100G45Z1.0H07
N110Z0.100
N120G01Z-0.007F15.0

[jackson]

Originally Posted by cncdigger It's a 1982 Mazak V 7.5 with a FANUC 6M control. It uses a G45 and negative value offsets a typical program start would be as follows: O1111(/P FACEPLATE) N20T07 N30M06T00 N40G00G20G17G90 N50T00 N60G54 N70M39 N80M03S2000 N90X19.100Y-1.9 N100G45Z1.0H07 N110Z0.100 N120G01Z-0.007F15.0

Ok i guess it is the year cause on my mori G44 is - G45 is tool possition offset increas and on the Haas it dosnt even offer a G45

[sa.snyder]

i just got in an old mazak powercenter (1982) fanuc 6 controls.
i dont have a manual for this machines so im a little lost. it dont use a g54. instead im using a "g45 x0.0 h31"
.........any info you can give me about this machine will be greatly appreciated!!! thank you