| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Metalwork Discussion Discuss everything relating to metal work. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#13
 
01-03-2007, 11:39 AM
| |||
| |||
| Or aluminum with a coating? anodized? ceramic?
__________________ DZASTR  |
|
#14
01-03-2007, 11:39 AM
| |||
| |||
| Being as its 'possibly' heavier, I'd guess Stainless.. because the part size is so small to start w/ the weight difference might not be noticable... [compared to a 1" x 4" x 1" bar or the like] some of the other exotic's like Inconel all of which would require lots of coolant among other things.. correct?? Jerry
__________________ JerryFlyGuy The more I know... the more I realize I don't (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#15
01-03-2007, 01:23 PM
| |||
| |||
| It isn't titanium, I bent the scrapped piece with some vice grips and it is far to strong to be aluminum, but since it bent around 90 degrees without breaking it wouldn't be a brittle material like titanium, which breaks with little deformation. |
| Sponsored Links |
| |
|
#16
01-03-2007, 01:50 PM
| |||
| |||
| the sheet meatl titaniun that i know has a very good memory like over 30degs so i don't think that it will brake i have bent titanium to like 150 to get good 90 out of it not it was only 20ga not shere if this help or hinders |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
