| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Metalwork Discussion Discuss everything relating to metal work. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-29-2006, 08:58 AM
| |||
| |||
I have a Gorton True Trace Master model 2-30, its slides on which Turkite is fixed or pasted got worn out. What should be the best method to replace with minimum cost & what precautions should be taken care of ?    |
|
#2
12-29-2006, 09:41 AM
| ||||
| ||||
| You could try one of the original creators of Turcite Busak + Shamban site. Also this one may help. http://www.mtsandtg.com/specialty/application I would imagine you need to remove the remains of the older application before applying new. Al.
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#4
12-29-2006, 06:31 PM
| |||
| |||
| sanjiv, You may want to contact your Saint-Gobain office in India, (91) 80 847 290 Grindwell Norton Ltd. Bangalore India
__________________ DZASTR |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
How to replace Turkite on slides 
Linear Mode
