| | |
how much is the radial depth norm for milling out say a circular pocket,counterbore? always the tool radius?
i have a .787" diameter by .433" deep. with a .472 thru hole. i'm using a 1/2" 2 flute end mill. i was just curious.thanx.
It depends on the feedrate, depth of cut, type of endmill and type of material. Other than that, it's cut and dried
First you get good, then you get fast. Then grouchiness sets in.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Posting Permissions
| | |
LinkBack URL
About LinkBacks
