Looking for some one to make small cap object.

[dbtoutfit]

I hope this is the correct placer to post comthing like this.

I need something like this made maybe jazzed up a bit or just a little cosmeticly different as this is someones elses design and I do not want to direct copy the design. I need this made and is about 1/2 inch long with a 3/8 deep ID of 1/4" and 1/8th deep ID of 3/16ths.

This will be made for an aluminum 3/16th tube that will have a rubber hose slide over it causing the tub to become 1/4 over all. The rubber hose is only on 3/8ths up the AL tube. The 3/16th ID of the back side of this part will need to be (guess-ta-ment) 1/32nd over 3/16ths as the AL tube it will be sliding up and down will be Powder Coated.

I would like to start with 50-100 of these if possable.

Hope this all makes sense
Here is a working version NOT OF MY OWN

[Runner4404spd]

its in the wrong forum and you need to make a detailed print.

[dbtoutfit]

can you suggest where is the correct place?

[Runner4404spd]

http://www.cnczone.com/forums/employment_opportunity/

this is the RFQ part of the site. its in the first block of links.

[dbtoutfit]

Heres detailed drawing.
Drawing