Which collets to use with BT40 Collet Chuck - CNCzone.com-The Largest Machinist Community on the net!

JMFabrications · #1 02-27-2006, 11:53 PM

I just got a used 3 Axis CNC Mill today, it came with a bunch of tooling including a collet chuck but no collets. Im not sure which collets to get, the only markings on the tool are Lyndex N4007-1000. I was looking at the ER collets but there a re few different numbers ER-11, ER-16 etc.... Anyone know how I can find out wich collets this holder takes?

Thanks,
Jim

B_Bueno · #2 02-28-2006, 08:11 AM

Look in your Weekly tool flyer or your tool supply book. The er series collets are listed in their respective capacities and for which tool holder [32,16] etc. they are made for.

LJ48 · #3 05-20-2006, 09:43 PM

HI
Just looked it up on the web I think it takes TG100 collets.
ck out thier web site

Oneaero · #4 05-18-2009, 09:21 PM

Goooogle it !

IT TAKES A " TG100 " from 3/64 to 1.00 inch

Keep your Powder dry!

Jon

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)