| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Metalwork Discussion Discuss everything relating to metal work. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-10-2005, 10:31 PM
| |||
| |||
Hello All, has anyone here been able to figure out how to cut an internal oil groove on Mazak 650 lathe with Nexus controller? Mazak said it couldnt be done on the T-2/3 and you can..but cant cheat the new one..or havent found a way as of yet. Any help would be appreciated. KEV   |
|
#2
11-12-2005, 05:16 PM
| ||||
| ||||
| Just a guess. how about an eia program , not mazatrol? Brad
__________________ IF ITS NOT BROKE YOUR NOT TRYING HARD ENOUGH Ashes to ashes , dust to dust , If it wasnt for Harleys the fast lane would rust. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
