Jaw turning fixture - CNCzone.com-The Largest Machinist Community on the net!

emergent · #1 09-16-2005, 03:09 PM

Is there a fixture for holding jaws in place while being turned to hold geometric parts. Someone told me about it a few years ago but I can't find anything related to it.

cadman · #2 09-17-2005, 01:28 PM

There are two types of fixturing to hold jaws in place for boring:

1. Rings and cams that you hold on the OD.
2. Rings with studs that go into the conterbores of the jaws.

One place that has both is www.usshoptools.com

CM

emergent · #3 09-18-2005, 07:47 PM

Thanks, Every little bit of help keeps my head out of the monitor screen!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)