Thread forming (roll tapping) tips please - CNCzone.com-The Largest Machinist Community on the net!

Toolz_86 · #1 06-29-2011, 01:12 PM

Hi all,
I need to roll tap m3 x 9 deep in st/st 316. I'll be using a tin coated hss m3 thread forming tap and drilling 2.8mm. I cant afford to break one!

Any tips would be appreciated? Speeds for example? It will be done on a haas vertical milling cnc machine.
Thanks

thedave · #2 06-29-2011, 02:45 PM

Verify the you are using the correct drill size for the tap. (Check with the manufacturer) They usually different that the drill size for cutting taps. Fastest way to break forming taps.

RICHARD ZASTROW · #3 06-30-2011, 06:26 AM

Get serious with the tap lube. Forming taps extrude metal into form and consequently need good lubrication. But you knew that.LOL

Dick Z

Delw · #4 06-30-2011, 10:33 PM

Try emuge(sp)taps for 316 I believe they make a roll tap.
make sure you hole size is to the maximum minor dia before tapping.
even though its only 9mm deep you may have to peck tap it twice.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Roll form tapping questions	stebanski	Haas Mills	10	05-11-2011 04:12 PM
Need Help!- Roll tapping.	Mitsui Seiki	G-Code Programing	2	06-16-2008 11:37 PM
Roll form thread die wheel question...	niggle	General Metalwork Discussion	0	06-11-2008 12:10 AM
Thread Forming	rrrrrgh	General Metalwork Discussion	2	07-27-2005 03:50 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)