Best contoller for old version mini-tech 2 Question

[art4x4]

Hi I have old version mini-tech 2 with ester air devises 3amp 1.8 deg lh233 step motors with 4 wires . I am going to buy controller box .Contact Keling Technology Inc they strongly recommend digital

KL-5056D-48 4 Axis CNC Stepper Motor Driver Controller: $769 Brand New 4 Axis Controller for NEMA23 and 34 Stepper motors Ready to plug and use, Tested With Mach3 1: 4 PCS KL-5056D Bipolar Drivers, 50V, 5.6A, DIP switch current setting, Automatic Idle-Current Reduction Over-Current, Over-Voltage & Short-Circuit Protection 2: 1 PCS 48V/12.5A power Supply, 115V/230V 3: 1 PC Breakout Board for 6 axis, Isolated signal . 4: With E-Stop, x, y, z limit Switch, Home Switch 5: 1 PCS Fan

I know also about Gecko Diver G540 CNC Stepper Motor Driver . Any recommendation ?

[Tkamsker]

Hi
I retrofitted a Klippfeld 10b turning lathe and combined Möller
I use emc2 because i dont like mach3 which eben Workshop
And use german quality Controller called tripple beast
Works as Charme i can help if needed
best
Reg
Thomas