How are gerotors made? - CNCzone.com-The Largest Machinist Community on the net!

04-08-2011, 10:02 PM

DennisCNC

Join Date: Aug 2005

Location: Clearwater, FL US

Age: 29

Posts: 816

How are gerotors made?

permalink

Any one seen a site that explains how gerotor internal and external gears are ground.

After looking at one for a while its pretty amazing how precises and smooth it is ground in the tight inside corners.

Thanks

Dennis

__________________
Dennis

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how was this made?	dustinwassner	Moldmaking	14	06-26-2010 10:46 PM
Made in the USA	IHCNC	Industrial Hobbies (Support forum)	45	05-20-2009 12:39 PM
Where to have PCB made.	mwalach	General Electronics Discussion	8	04-24-2009 07:08 AM
Made in Australia (Made in taiwan, china)	carbidecraters	General Metalwork Discussion	0	01-10-2006 02:05 PM
Home made CNC mill (and some products made by it)	gcamlibel	DIY-CNC Router Table Machines	23	04-05-2004 05:54 PM

All times are GMT -5. The time now is 10:30 AM.