| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Metalwork Discussion Discuss everything relating to metal work. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-01-2010, 04:49 AM
| |||
| |||
Hi there, I am based in Kuala Lumpur, Malaysia and I am looking for someone based in KL who's able to make metal parts I design. They are mostly made out of Aluminum or Brass and sizes are below 90/100mm. thank you!  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Job Opening engraving expert needed | BILL WRIGHT CCR | Employment Opportunity | 0 | 08-27-2010 06:34 PM |
| Expert on solid state relay needed..... | planekrazie | General Electronics Discussion | 7 | 04-13-2009 10:04 AM |
| Expert advice needed Rubber grades | Al_The_Man | Mechanical Calculations/Engineering Design | 6 | 11-15-2008 10:39 AM |
| Patient expert needed for newb RTAPI error | oakes3 | LinuxCNC (formerly EMC2) | 13 | 06-28-2008 03:12 AM |
| PC Based Hardware Controller Kit Needed | pmartin223 | General Electronics Discussion | 6 | 06-13-2004 10:28 AM |
| | |
Linear Mode
