Results 1 to 2 of 2

Thread: what to do with the swarf

  1. 10-22-2010, 08:33 PM #1
    moti barski
    moti barski is offline
    Registered
    Join Date
    Oct 2010
    Location
    israel
    Posts
    2
    Downloads
    0
    Uploads
    0

    what to do with the swarf

    what do you do with large amounts of swarf ?
    can you sell it if so to where ?

  3. 10-22-2010, 08:40 PM #2
    UVsaturated
    UVsaturated is offline
    Registered
    Join Date
    Oct 2010
    Location
    USA
    Posts
    1
    Downloads
    0
    Uploads
    0
    You can sell it for scrap. Do you have any metal recycling centers around Israel?

« Beginner. What size drill bit for snug fit 12mm hole? | Small single-point internal threading »

Similar Threads

  1. Swarf Fetishist
    By wholepair in forum General Metalwork Discussion
    Replies: 3
    Last Post: 09-27-2011, 04:23 PM
  2. What should my aluminum swarf look like?
    By guru_florida in forum Taig Mills & Lathes
    Replies: 23
    Last Post: 04-12-2009, 02:15 PM
  3. Swarf Management
    By keen in forum Tormach Personal CNC Mill
    Replies: 4
    Last Post: 04-09-2009, 05:51 PM
  4. Swarf again..
    By Tugiyana in forum Mastercam
    Replies: 2
    Last Post: 01-07-2008, 03:00 PM
  5. Swarf recycling?
    By kong in forum General Metalwork Discussion
    Replies: 1
    Last Post: 02-26-2005, 04:29 PM

Posting Permissions



About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.