cylindrical fixture - CNCzone.com-The Largest Machinist Community on the net!

MBG · #1 06-23-2005, 10:13 PM

For a surface grinder. I used one before but never got the name of who made it.

Who makes these fixtures?

DieGuy · #2 06-24-2005, 12:06 AM

With 5C collets? There are lots of manufactures out there. Check E-bay, I thing I saw a couple on there for cheap.

DareBee · #3 06-24-2005, 07:54 AM

The really good fixtures have a V block that you indicate to centre (or offset) manually. They are by Suburban & Harig (others?) start at about $2k, hard to run a tool room without 1.

MBG · #4 06-24-2005, 10:50 AM

Originally Posted by DareBee

The really good fixtures have a V block that you indicate to centre (or offset) manually. They are by Suburban & Harig (others?) start at about $2k, hard to run a tool room without 1.

wow two grand? and I could run one on a surface grinder? all I wnat to do is side grind a cylindrical surface.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
toolbit grinder fixture	jimglass	Toolgrinding & Toolgrinding Machines	12	09-26-2006 07:19 AM
Gibbs for mouldmakers and fixture builders	krustykrab	GibbsCAM	24	08-19-2005 04:36 PM
mach2 doesnt like my fixture changes?	JFettig	Mach Software (ArtSoft software)	7	05-20-2005 11:02 AM
material for fixture	MBG	General Metalwork Discussion	9	03-12-2005 02:37 PM
Any ideas to secure this pcb to a fixture?	Binow	DIY-CNC Router Table Machines	7	07-29-2004 01:15 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)