Press fit

[FalconMachine]

I need some help finding a standard chart for press fit parts. I have to drill a hole for a .0932 dowel pin to be pressed into the hole. The print calls for a
FN-1 or better press fit. Does anyone know what size hole I need to drill or even better show me where I can find a chart? If this is not the right Forum I apologize.

[RICHARD ZASTROW]

Try to "google" press fit or interference fit. I know the charts are out there bacause I found them myself. Right know, I can't help you. Off to work and all that. Maybe later if somebody else didn't find it.

Dick Z

[easymike29]

http://www.scribd.com/doc/9724085/Press-and-Shrink-Fits

[MikeZee]

You know what - what has to happen here is that a 3/32 dowel pin gets knocked into a hole with a hammer, that's all. However, it's Sunday here so when I get to the shop tomorrow I'll see if I've got anything that resembles what you might need. My guess would be - go - .0002 / .0004 on size and you should be somewhere in the ballpark.

[FalconMachine]

Thanks, guys that's what I needed.