| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Metalwork Discussion Discuss everything relating to metal work. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#3
 
08-12-2010, 11:12 AM
| |||
| |||
| What surface finish are you after, and what is acceptable taper?  |
|
#4
10-21-2010, 07:57 AM
| |||
| |||
|
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Newbie- cylinder | copperhead4321 | Solidworks | 1 | 05-13-2008 10:20 AM |
| Easiest way to polish inside of an aluminum cylinder? | jmccalip | General Metalwork Discussion | 11 | 02-24-2008 06:14 PM |
| Polishing Bobs | weiyungst | General Metalwork Discussion | 2 | 12-28-2007 10:55 AM |
| 4 cylinder | bluejets | I.C. Engines | 8 | 07-04-2007 09:26 AM |
| compressor piston cylinder compared to an IC engine piston cylinder | CNCnUtZ | I.C. Engines | 1 | 12-28-2003 07:06 PM |
| | |
Linear Mode
