Matsuura MC500 VS Ladder Logic - CNCzone.com-The Largest Machinist Community on the net!

nnpepe · #1 03-22-2009, 10:03 AM

I have a customer with a Matsuura MC500 VS circa 1982 with a EN4-00443A Operators Station. I'm trying to access the ladder logic, I have the machine electrics but need access to the ladder through the control. The actual control for the machine is a Yasnak MX1. I press the DGN switch on the Operators station and get the bits representing I/O but I have no way of knowing what they are for. Thanks for your help.

kulk_sd · #2 02-28-2012, 09:48 PM

Dear Sir,
I have a 2000V VMC. It is stuck without any error message. There are no faults shown anywhere, but machine dont run.
Please advice on getting the ladder logic softwares, wiring diagrams etc.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help Matsuura mc500 with pnc 500 indexer	antatps3	Knee Vertical Mills	0	03-20-2009 07:21 PM
How to decifer Ladder Logic???	theemudracer	Fanuc	6	06-01-2008 08:28 AM
FANUC Ladder Logic Backwards?	obieron	Fanuc	4	12-18-2007 02:17 PM
5v for logic...	WilliamD	General Electronics Discussion	4	02-10-2006 04:52 PM
Ladder logic	Chris Roth	Deckel, Maho, Aciera, Abene Mills	4	12-26-2005 10:29 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)