TL25 Haas Lathe active tooling

[alphamoose]

I'm trying to use the active tooling on a TL-25 Haas Lathe. I have written a small program in MDI mode and tried to run it. I'm able to rotate the main spindle into position, I lock it. I activate the live tooling, but when I go to MOVE the head, alarm 186 pops up telling me I'm basically trying to move the head but the main spindle is not rotating. How can I disable this alarm.

[mcamiller]

Refer to page 111 of the Haas manual. You might have to set Parameter 315 from a 0 to a 1.