We bought a used Mighty Comet VMC about 2 months ago. It was sitting in a warehouse for a while before we bought it. When we got it in the shop and all hooked up we had to reload the user and machine parameters. Everything works fine except that the machine is not sending a signal to the way oil pump to turn on, so it gives a "lube pressure fault" about every 15 minutes or so. The pump works manually, only in automatic mode will it give the alarm. My question is this, is there a parameter that I need to change to make the machine get the signal it needs? Perhaps a PLC timer parameter or a PMC parameter? I have done all that I can with the manuals that I have and it is very difficult to get an answer for Might USA. I keep getting the run around. If anyone has any suggestions I am all ears.

Thanks,
Josh