Results 1 to 2 of 2

Thread: powering up hardinge DV-59

  1. 06-30-2008, 06:33 PM #1
    logos
    logos is offline
    Registered
    Join Date
    Jul 2003
    Location
    United States
    Posts
    51
    Downloads
    0
    Uploads
    0

    powering up hardinge DV-59

    I am about to power up my Hardinge I am using a rotory phase convertor. Does anyone know where the hot leg goes? (Some call it the wild leg)

  3. 07-07-2008, 08:10 AM #2
    logos
    logos is offline
    Registered
    Join Date
    Jul 2003
    Location
    United States
    Posts
    51
    Downloads
    0
    Uploads
    0

    different forum?

    Should I post this in different forum? If so which one.

« 3 projects of CNC Router 3Axis, 4 Axis and 5 Axis | Machining alumimium »

Similar Threads

  1. powering down the control
    By Joe Miranda in forum Milltronics
    Replies: 3
    Last Post: 04-12-2008, 09:48 PM
  2. Fanuc OT-C Not Powering Up
    By JerryH in forum Fanuc
    Replies: 4
    Last Post: 08-22-2007, 07:34 AM
  3. Input signal fails when powering up drivers.
    By Witsenburg in forum General Electronics Discussion
    Replies: 2
    Last Post: 07-02-2007, 04:02 PM
  4. hardinge ahc
    By Runner4404spd in forum General Metal Working Machines
    Replies: 0
    Last Post: 04-11-2007, 10:10 AM
  5. Transformer on ebay AU for powering CNC
    By Greolt in forum Australia, New Zealand Club house
    Replies: 0
    Last Post: 06-19-2006, 02:54 AM

Posting Permissions



About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.