Well, for $10,000.00 in US FUNDS you better not expect much. We have more than that tied up in just the Software (AlphaCam Advanced Mill). 10 Grand is OK to spend if you are a hobbiest just starting out. But if you plan on using it for production of Goods to make some serious $$$ then you had better save up a little more. In fact, a lot more. YOu should be looking at $75,000.00 Machines or even higher. My first one was over $150,000.00 but there isn't much that it can't do. It paid for it's self in 4 years running it 2 shifts. You need high feed rate capabilities and large capacity in order to compete in todays market. You don't want to have to put money in the Box with the parts to send them down the road. You'll go broke. I suggest doing a lot of research and go to some Trade shows and see what's out there. An Auto Tool changer is a must have feature also with at least 6 or 8 Tools. There are many different styles of those.
MasterCam level 1 is $5,000.00 but is a good choice for programming as I used it for 6 years with great results.