Troubleshoot DNC

[phoodieman]

I'm trying drip feed to a Lagunamatic 3 axis mill with a desktop PC. I have the serial connection hooked up. Mastercam is sending the programs, but the controller says it doesn't have communication. It's a Dynapath controller. Any tips?

phoodieman

[blksmith]

First thing I would check is to be sure your comm ports are set the same on both cnc and pc

[motomitch1]

Is the controller set in the rs232c mode?

[Green Button]

Cable problem ?

Please check: cadem.com

[phoodieman]

Cable is good. Pinout is right. The controller is ready. I think it might be settings in the PC, but everything seems to be right. I'm stuck.....

Phoodieman

[motomitch1]

Is it a Dynapath 20 controller?

[frogier]

Do you load your programs using this desktop?